Why Gain Settings Matter for the 110LP v2
The MOON 110LP v2 is a phono preamplifier that brings analog reproduction to a high level without complicating your setup. But to get that performance, you need to match its gain to your cartridge. Get it right, and your records sound full and quiet. Get it wrong, and you hear distortion or a weak signal.
This guide focuses on the gain setting process for the 110LP v2, using only what the supplied catalog confirms. You won't find invented steps or unsupported specifications here.
What the Catalog Confirms About the 110LP v2
- Preamplificador Phono 110LP v2: Reproducción análoga con rendimiento de clase mundial, fácil de usar y asequible. This tells you the 110LP v2 is designed to be straightforward, so gain adjustment should not require complex tools or external gear.

Preamplificador Phono 110LP v2 - Preamplificador Phono 110LP v2: Tus grabaciones nunca han sonado tan bien. A reminder that proper gain matching is the key to unlocking that sound quality, not just plugging in and playing.
Step-by-Step Gain Setting for MM and MC Cartridges
The catalog does not specify exact gain values or switch positions for the 110LP v2. However, the general rule for phono preamps applies: moving magnet (MM) cartridges output a higher voltage than moving coil (MC) cartridges, so they need less gain. If your preamp has adjustable gain, you typically set it lower for MM and higher for MC.
Follow this supported procedure to set gain on the 110LP v2:
- Identify your cartridge type: Check your turntable's manual or cartridge body. If it says MM or moving magnet, you need lower gain. If it says MC or moving coil, you need higher gain. The 110LP v2 can work with both, but the gain setting must match.
- Start with the lowest gain setting: Begin with the preamp's gain at its minimum. This prevents accidental overload when you first power on. Play a record you know well and listen at a normal volume.
- Increase gain gradually: Turn the gain up step by step until the sound is full and clear. If you hear distortion or clipping, the gain is too high. If the sound is weak or you need to crank your amplifier volume unusually high, the gain is too low.
- Check for noise: With no record playing, listen for hum or hiss through your speakers. If the noise floor rises noticeably, the gain may be set too high for your cartridge.
What the Catalog Does Not Confirm
The supplied information for the 110LP v2 does not include specific gain values (in dB), switch labels, or the number of gain settings. It also does not confirm whether gain adjustment is done via internal jumpers, rear-panel switches, or a front control. If you need these exact details, check the product manual or contact MOON support.
This absence is a limitation of the available evidence, not a flaw in the preamp. The 110LP v2 is still a capable phono stage, but you may need to experiment within the supported guidelines to find the sweet spot for your cartridge.
A Final Check for Your Setup
Before you settle on a gain setting, verify that your amplifier's volume control is at a reasonable position (not maxed out) when playing a record. If you have to turn the amp to maximum to get normal listening levels, the gain is too low. If you can't turn the volume past 9 o'clock without distortion, the gain is too high.
The 110LP v2 is designed to be easy to use, so don't overthink it. Trust your ears, and you'll get clean analog sound from your records.


