What Bi-Amping Means for Your System
Bi-amping is a speaker connection method that uses separate amplifier channels for the low and high frequencies of a speaker. This can reduce intermodulation distortion and give you tighter control over bass and clarity in the treble. The MOON 761 power amplifier is designed for this role, delivering stable, transparent power to each driver without crosstalk.
How the MOON 761 Supports Bi-Amping
- 761 Amplificatore di potenza: Il MOON 761 ha un compito da svolgere, e lo svolge con sicurezza e raffinatezza. Questo amplificatore di potenza è in grado di fornire senza sforzo segnali audio delicati con assoluta trasparenza e precisione. The 761's design prioritizes signal purity and predictable behavior, making it a suitable foundation for bi-amping where consistent, clean power delivery to each driver is critical.

761 Amplificatore di potenza
Setting Up Bi-Amping with the MOON 761
The following steps assume your speakers support bi-amping (separate binding posts for low and high frequencies) and that you have two MOON 761 units or a multichannel amplifier with dedicated channels.
- Confirm speaker compatibility: Check that your speakers have two sets of binding posts (usually labeled Low and High) and that they are not jumpered. If jumpered, remove the jumpers to separate the frequency paths.
- Connect the preamplifier to both 761 units: Use balanced or unbalanced cables to connect your preamplifier's left and right outputs to the inputs of both 761 amplifiers. One 761 will drive the low-frequency section; the other will drive the high-frequency section.
- Wire the speakers: Connect the amplifier designated for low frequencies to the speaker's low-frequency binding posts. Connect the other amplifier to the high-frequency binding posts. Use identical cable lengths and gauge for consistency.
- Power on and verify: Turn on the preamplifier first, then the 761 amplifiers. Play a familiar track and listen for balanced output. Adjust level matching if your preamplifier or speakers allow it.
Bi-Amping vs. Bi-Wiring
Bi-wiring uses a single amplifier channel but two separate speaker cables to the same driver set. Bi-amping uses separate amplifier channels, which can improve dynamic range and reduce strain on the amplifier. The MOON 761's design—focused on stability and low noise floor—makes it well suited for the bi-amping approach, especially in systems where bass control and treble clarity are priorities.
What the Supplied Information Does Not Cover
The catalog does not specify exact power output per channel, recommended crossover frequencies, or specific speaker impedance limits for bi-amping. For optimal results, consult your speaker's manual for crossover recommendations and ensure your preamplifier can drive two power amplifier inputs without signal degradation. If your speakers require active crossovers, additional components may be needed.


