Stand 22 Speaker Stands: Setup and Placement Tips

By Canadian High-End Audio Manufacturer | MOON by Simaudio | Published: 2026-10-28

Category: How-to Guides

Learn how to set up MOON Stand 22 speaker stands for optimal sound. Step-by-step placement tips to get the best from your bookshelf speakers.

Quick answer

Set up your Stand 22 speaker stands by first assembling them on a level surface, then positioning them at ear height and toeing them in toward your listening spot. Follow the steps below to get the best sound from your MOON Voice 22 bookshelf speakers.

Why proper stand setup matters

Speaker stands do more than hold your bookshelf speakers at the right height. They isolate the speakers from floor vibrations and let you fine-tune the soundstage. The Stand 22 is custom-made for the MOON Voice 22, with a top plate that fits flush into the recessed bottom of the enclosure. This creates a clean, integrated look and ensures a stable, uncluttered appearance.

Getting the placement right is just as important as the stand itself. Small adjustments in distance from the wall or toe-in angle can noticeably change bass response and imaging. The steps below walk you through the process from unboxing to fine-tuning.

Trade-offs to keep in mind

If your room has thick carpet or an uneven floor, the stand's base might not sit perfectly flat. In that case, use the adjustable spikes (if available) or a thin shim to level the stand before placing the speaker. Also, remember that the Stand 22 is designed specifically for the Voice 22; using it with other speakers may not give the same flush fit.

Placing the stands too close to a wall can make the bass sound boomy, while pulling them too far out can thin out the lower frequencies. You'll need to experiment within the constraints of your room.

How to set up your Stand 22 speaker stands

Unbox and inspect: Carefully remove the stands from the packaging and check for any damage or missing parts. Place all components on a soft surface to avoid scratches. Keep the packaging in case you need to return or move the stands.
Assemble the stands: Attach the base and top plate according to the included instructions. Tighten all screws firmly but avoid overtightening, which can strip threads. Use a torque wrench if available to ensure even tightness.
Position the stands at ear height: Place the stands where your ears will be when listening. The tweeter should be at ear level for best high-frequency response. Adjust the height if your stands have adjustable spikes. Sit in your normal listening position to verify the height.
Place the speakers on the stands: Lift the Voice 22 speakers and gently lower them onto the top plate, ensuring the recessed bottom aligns with the plate. The flush fit should make the stand disappear visually. Avoid sliding the speaker across the plate to prevent scratches.
Set the distance from the wall: Start with the stands about 20-30 cm (8-12 inches) from the rear wall. Move them closer for more bass or farther for less boom, but avoid placing them directly against the wall. Use a measuring tape to keep both speakers equidistant from the wall.
Toe in the speakers: Angle each speaker slightly toward your listening position. Start with a 15-degree toe-in and adjust until the soundstage feels centered and the imaging is sharp. Small adjustments of a few degrees can make a big difference.
Level and stabilize: Check that both stands are perfectly level using a bubble level. If the floor is uneven, adjust the spikes or add shims to prevent wobbling. A stable stand prevents vibrations that muddy the sound.

About the Stand 22

Stand 22: The top plate of the Stand 22 fits flush into the recessed area in the bottom of the Voice 22 enclosure and disappears, creating a pure and uncluttered appearance. This flush fit ensures a stable, integrated connection between speaker and stand, reducing unwanted resonance and improving overall sound clarity.
Stand 22