Voice 22 Loudspeaker Placement Tips for Better Imaging

By Canadian High-End Audio Manufacturer | MOON by Simaudio | Published: 2026-10-18

Category: How-to Guides

Learn where to place your MOON Voice 22 speakers for accurate stereo imaging, solid bass, and a believable soundstage. Step-by-step setup tips included.

Quick answer

Start with your Voice 22 speakers 24 to 36 inches from the back wall, toe them in toward your listening position, and adjust until the soundstage locks into place. These five steps will get you most of the way to accurate imaging.

Why placement matters more than you think

The MOON Voice 22 is designed to preserve the presence and dynamics of acoustic instruments, but that realism only comes through when the speakers interact well with your room. The distance from the wall affects bass balance, while toe-in changes the focus of the stereo image. Getting both right takes a few minutes and transforms the listening experience.

Every room behaves differently, so treat these steps as a starting point. The goal is to find the position where the music feels anchored between the speakers, with a stable center image and natural depth.

Trade-off: bass depth vs. imaging focus

Moving the Voice 22 closer to the wall increases bass output but can make the midrange sound boomy and blur the stereo image. Conversely, pulling them far into the room tightens the bass but may reduce low-end weight. There's no single correct distance; you'll need to balance the two based on your room and taste.

If your room is small or heavily furnished, start with the speakers closer to the wall (around 24 inches) and listen for any boominess. In larger rooms, you can afford more distance.

Voice 22 Placement in 5 Steps

Position the speakers symmetrically: Place the Voice 22 speakers at equal distances from the side walls and at the same distance from the back wall. Use a tape measure to be precise; even a few centimeters of asymmetry will shift the center image. Check that the left and right distances match to within 1 cm.
Set the distance from the back wall: Start with the rear of each speaker 24 to 36 inches (60-90 cm) from the wall behind them. If the bass sounds boomy, move them farther out; if it sounds thin, bring them closer. Listen to a bass-heavy track to judge the balance.
Create an equilateral triangle: Position your listening seat so that you and the two speakers form an equilateral triangle, with the speakers angled toward you. This is the sweet spot for stereo imaging. Measure the distance between the speakers and match it to the distance from each speaker to your ears.
Toe-in for focus: Angle each speaker inward so the front baffles point directly at your listening position. Start with full toe-in, then gradually reduce it until the center image is solid but the soundstage feels open. Small changes (a few degrees) make a big difference; adjust in tiny increments.
Fine-tune with a familiar recording: Play a track with a centered vocal and clear instrumental placement. Move the speakers in small increments (1-2 cm) forward, backward, or sideways until the vocal locks in the center and the instruments have stable positions. If the vocal sounds 'thick' or 'chesty', the speakers are too close to the wall; if it sounds 'distant', they may be too far apart.

About the MOON Voice 22

Voice 22 – Diffusori: The Voice 22 is the result of extensive R&D, giving MOON its own 'voice' for the first time, with a focus on sonic transparency and realism. Because the speaker aims to preserve the presence and dynamics of acoustic instruments, placement that preserves timing and imaging is critical to achieving that transparency.
Voice 22 – Diffusori